oOLim0o (August 4th, 2010 @ 6:05 am)

Are these tools usually rent-able at the local home depot or lowes?

oOLim0o (August 4th, 2010 @ 6:04 am)

Thank you for the helpful videos!

vanessabella1 (January 19th, 2010 @ 9:55 pm)

Just divide 130 Degree corner by 2 and you have 65 degrees each peice. Most outside corners are 90 degrees so it would be a very sharp corner at 130 degrees.

zelmergobi (January 16th, 2010 @ 8:19 pm)

if they are inside corners try coping moldings and if that doesn't work then put the molding against the ceiling and trace the height and projection with a pencil on both sides of the corner making sure wall lines align and then mark the molding where it will meet and find your angle on the saw...hope this helps

AsktheBuilder (January 1st, 2010 @ 11:49 pm)

Easy...... Go watch my Fancy Crown Molding Corners video and read that same column at my AsktheBuilder web site.

myoung1204 (January 1st, 2010 @ 10:25 pm)

How do you cut outside corners that are not square? I have several 130 degree corners in my house. It is driving me crazy!!

AsktheBuilder (October 29th, 2009 @ 1:06 pm)

You have the keyword in your question! The angle in a gable end is NOT a compound cut. The crown is not going around a corner. Both pieces running up the gable are in the same plane. Think about how easy that cut is....... Think door or window casing.

akdamagecontrol (October 29th, 2009 @ 7:33 am)

How about compound angles, like gables? We spent all day and did not successfully make a single joint.

tipetu (March 4th, 2009 @ 6:10 pm)

that was actually a good idea!

AsktheBuilder (December 25th, 2008 @ 10:38 pm)

By tacking a small strip of wood to the table that holds the molding in position

vivamexcabrones (December 25th, 2008 @ 3:57 am)

Thank you. Does an old school powerless miter box work well? If so how do you prevent the molding from sliding outward as you cut the angle(creating like a 43 or 47 deg. miter cut)? Thank you very much.

AsktheBuilder (November 16th, 2008 @ 3:31 pm)

Yo hablo espanol.